![]() It Performs similarly if not better than the 212 EVO, smaller, easier to install, quieter, and cheaper./quotemsg WTF, I have OCed 6600k at 4. It is an option for high bandwidth users. quotemsg20003065,0,2455202Also, the Cooler Master 212 EVO isn't a very good CPU cooler to buy anyways. no VGA card) on H67 chipset motherboards. Note: Turbo USB 3.0 utilizes 8 PCIe VGA lanes, so it is only possible to enable it with a single graphics card running at PCIe x8 on P67 chipset motherboards, or while using Intel ® HD Graphics from the CPU (i.e. This provides approximately 10% better performance than when it is disabled and USB 3.0 traffic is directed through the chipset. When GIGABYTE's Turbo USB3.0 feature is enabled, it provides the fastest possible USB3.0 performance by allocating PCIe lanes to directly connect the CPU and USB 3.0 controller chip. Turbo USB3.0 – Boosts Performance by Up To 10% Additionally, backwards compatibility with USB 2.0 assures users of long term use of their legacy USB 2.0 devices. With superfast transfer rates of up to 5 Gbps, users are able to experience a theoretical 10x improvement over USB 2.0. There must be something wrong either with software or board.GIGABYTE motherboards boast SuperSpeed USB 3.0 technology made possible through an additional onboard host controller. Each RAM module is showing same frequency and other attributes. This time both apps detected all of the modules as PC3-10700. So I shuffled the RAM modules (in accordance to combination) and ran both apps again. On the other hand, CPUz detected all of the RAM mondules as PC3-1077. I found ET6 was detecting one RAM module on DDR3_1 as PC3-9800G and others as PC3-10700. I ran both CPUz and EasyTune6 (from gigabyte). Later that day, when I tested it on my pc again with same combination it didnt detect any dual channel configuration. I took RAM modules to vendor (MSY in Altona, VIC) and test them on their system. 8GB from same kit on following slots as per the motherboard manual: So I tried only one kit which is 2 X 4GB RAM i.e. ![]() I ran CPUZ too see if memory is running in dual channel mode and there was nothing in Channel # section. I am unable to get dual channel enabled with 4 X 4GB RAM. ![]() > 2 X 8GB KIT (Model:F3-10666CL9D-8GBXL and 2X4GB in each kit) = 16GB RAM > Gigabyte GA-P67A-UD4-B3 (rev 1.1) motherboard with BIOS version F3 I recently built a system with following main components: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |